Att PagePac Plus AmpliCenter User Manual download pdf (Page 32)

NOTE:

THESE TERMINALS ARE REDUNDANT

PAGE INPUT CONNECTION. USEFUL

WHEN A MODULAR RJ-11 PLUG AND

CABLE IS NOT SUITABLE.

SET TO

HOST SYSTEM

REQUIREMENTS

TO HOST TELEPHONE

SYSTEM OR PAGING

SYSTEM CONTROLLER

PBX HOST

TELEPHONE

SYSTEM

LOOP START TRUNK PORT

OR DRY LOOPO PAGE PORT

Figure 3-6. AmpliCenter Interconnection to Telephone System or to Controller

Connection to

The page input cord that connects to the PagePac Plus AmpliCenter has a

AmpliCenter

standard 4-wire RJ-11 type plug or leads on the end that connects to the

AmpliCenter. The other end of the cord, depending on the host system,

may have a special 25-pair connector, spade-tip leads, or an RJ-11 type

plug.

The page input cord conductors are usually color-coded and are

connected to the host system as follows.

1. Connect black wire to the paired dry contact control lead ground.

2. Connect yellow wire to the paired dry contact control lead C1.

3. Connect red wire to system ring R.

4. Connect green wire to system tip T.

Installing the Hardware 3-11

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 47 48

No comments

Att PagePac Plus AmpliCenter User Manual Page 32