Please also readPart 1 — Important Product InformationUSER’S MANUAL Part 2© 2005 Advanced American Telephones. All Rights Reserved.AT&T and the Gl
Table/Desk Installationcontinued from page 5• If you have two one-line wall jacks, use both long line cords.Insert one end of the first cord into the
5 Check for dial tone.Press L, lift the handset, press K or press h(with a headset connected and batteries installed), and listen for a dial tone. The
Wall Installation1 Remove the base wedge.If the base wedge is attached, remove it following the directions in“Battery Installation” beginning on page
9INSTALLATIONINSTALLATION• If you have two separate one-line wall jacks, use two line cords (the short cord and one of the long cords). Plug oneend of
Switchable Data PortIf you want to connect another device (such as a modem or fax machine) to the wall jack, you can use the jack on the phone labeled
11TELEPHONE OPERATIONTELEPHONE OPERATIONMake a CallPress a LINE button and lift the handset— OR —Press K— OR —Press h, then dial the call.NOTE: If yo
Switch Between Handset, Headset,and SpeakerphoneTo switch from handset to headset orspeakerphone, press h or K.To switch from headset or speakerphone
RedialPress L or l, then lift the handset — OR — Press K— OR —Press h, then press a to call the last number (up to 24 digits) dialed on the line.Erase
HoldPress H to put a line on hold. You can hang up the handset.To return to the call, press the appropriate LINE button and lift the handset— OR — Pre
MuteMute allows you to hear the other party, but the otherparty can’t hear you.To turn Mute on, press M. The MUTE light goes on.To return to the conve
982_CIB_3ATT 2/4/05 9:52 AM Page 2
16TELEPHONE OPERATIONTELEPHONE OPERATIONConference CallsYou can use both lines at the same time to set up athree-way conference call.1 Make or answer
17TELEPHONE OPERATIONTELEPHONE OPERATIONLights and What They Mean LIGHT: STATUS: MEANS:LINE (RED) On steadily This line is in use.—OR—This line is no
18TELEPHONE MEMORYTELEPHONE MEMORYThis telephone has 24 memory locations where you can store phonenumbers you wish to dial with only one or two key pr
19TELEPHONE MEMORYTELEPHONE MEMORYStore a Memory Number1 Press K, press h or lift the handset.2 Press and release G. You will hear a beep.3 Enter the
20GENERAL PRODUCT CAREGENERAL PRODUCT CARETo keep your phone working and looking good, follow these guidelines:• Avoid putting it near heating applia
21TECHNICAL SPECIFICATIONSTECHNICAL SPECIFICATIONSTECHNICAL SPECIFICATIONSTECHNICAL SPECIFICATIONSREN 1.0BBattery Power 4 AAProduct Weight 2.06 pounds
22IN CASE OF DIFFICULTYIN CASE OF DIFFICULTYIf you have difficulty operating this phone, try the suggestions below.For Customer Service, visit our web
23IN CASE OF DIFFICULTYIN CASE OF DIFFICULTYTELEPHONE OPERATIONPROBLEM SOLUTIONAutomatic Redial • If the phone rings during the Automatic Interrupted
24IN CASE OF DIFFICULTYIN CASE OF DIFFICULTYTELEPHONE MEMORYPROBLEM SOLUTIONWarning Tone Install four charged AA batteries. (See Sounds When You “Bat
3-Way Calling 15Aa 13, 19, 24Automatic Redial 3, 4, 13, 23Bbatteries 2, 4, 7, 10, 11, 12, 13battery cover 4CCall Waiting 15C 16conference ca
PRODUCT OVERVIEW...1BEFORE YOU BEGIN ...2Parts List ...2Tools Needed ...
Ttemporary tone 22touch tone 6, 22two-touch memory 18Vvolume 12Wwarning tone 24wedge 2, 3, 526INDEXINDEX982_CIB_3ATT 2/4/05 9:52 AM Pag
982_CIB_3ATT 2/4/05 9:52 AM Page 27
© 2005 Advanced American Telephones.All Rights Reserved.AT&T and the Globe Design are trademarks of AT&T Corp., licensed to Advanced American
982_CIB_3ATT 2/4/05 9:52 AM Page ii
This AT&T Two-Line Speakerphone 982 can be used with one or twoincoming telephone lines and features a speakerphone for hands-free use.It is heari
BEFORE YOU BEGINBEFORE YOU BEGINParts ListYour box should include:2BEFORE YOU BEGIN1This Quick Start Guide provides basic instructions. For additio
Before You InstallTo use this product as a two-line phone, you must have a two-line modularwall jack or two separate one-line modular wall jacks. To
Battery Installationcontinued from page 33 Press the tab as shown and pull to remove the batterycover. Insert four new AA batteries (purchased separat
Table/Desk Installation1 Attach the wedge.Insert the bottom tabs into the slots as shown. Push gently on the tabs at the large end of the base while l
Comments to this Manuals