Att 972 User Manual download pdf (Page 7)

Battery Installation

Before using the telephone, install a 9V battery (not included). In case

of a power failure, you will be able to use the phone normally if a fresh

9V battery is installed, but Caller ID information will not be displayed. This

phone has a Memory Loss protection feature and will store your caller ID

information, memory and programmed settings until power is restored.

When battery power is low, LOW BATT shows on the display to alert you.

Replace batteries promptly.

CAUTION: Always disconnect all cords and remove base before

installing new batteries.

1 Remove the label covering the display screen.

2 Turn the telephone upside down.

3 Remove the base (Figure 1).

Place your thumbs in the two openings at the large end of

the base. Push down with your thumbs, and lift the base up

and away from the phone.

4 Open the battery compartment door (Figure 2).

Press on the tabs and remove the door.

5 Install one new 9V battery (Figure 3).

6 Replace the battery compartment door.

7 Turn to Step 1 in “Table/Desk Installation” or “Wall Installation”.

INSTALLATION

Figure 2

Figure 3

Figure 1

972_00_1ATT BOOK 12/4/01 1:36 PM Page 4

1 2 3 4 5 6 7 8 ... 29

No comments

Att 972 User Manual Page 7